Construction wheel loader Bucket wear runners

Wheel loader bucket wear runners, also known as wear blocks, are bolt-on protective wear components used to protect high-wear bucket surfaces and reduce abrasion during loading, digging, and ground contact.

Wear runners are typically installed on the underside or bottom of wheel loader buckets. Sometimes they can be installed on side plates or side rock deflectors depending on the wear requirement.

Enstruc Wear Blocks are designed for 15-50 tonne wheel loaders. Our wear blocks are suitable for loader buckets on Cat 926, 930, 938, 950, 962, 966, 972, 980, 982, 986; Case 421G, 521G, 621G, 651G, 721G, 821G, 921G, 1021G, 1121G; Hitachi ZW160, ZW180, ZW220, ZW250, ZW310; Hyundai HL930, HL940, HL955, HL960, HL970, HL975, HL980, HL985; Komatsu WA200, WA270, WA320, WA380, WA470, WA475, WA480, WA485, WA500; Liebherr L546, L550, L556, L566, L576, L580, L586; Volvo L60, L70, L90, L110, L120, L150, L180, L220, L260, L350; and other similar models. For larger wheel loaders, see our range of Quarry Wheel Loader Wear Blocks and Mining Wheel Loader Wear Blocks.

Yes. They protect structural areas and high-wear areas of the loader bucket, significantly reducing wear and extending service life in abrasive materials.

Enstruc wear blocks for construction wheel loaders are designed for maximum durability and quick installation and removal. The base plate is welded to the bucket and the wear block is attached to the base plate using heavy duty bolts and nuts.

The wear block is made from wear-resistant steel alloys, which are cast, quenched and tempered for enhanced abrasion resistance and impact toughness.

Yes. Enstruc can design and manufacture custom wear block shapes, sizes, and thicknesses to suit specific wheel loader bucket designs and wear patterns.

Yes. Enstruc delivers loader wear blocks and bucket protection parts worldwide.